Glow Fire Neptun Mode D'emploi page 55

Temperature limitation
This heater is equipped with a temperature limit control. When the heater reaches an unsafe
temperature, the heater turns off automatically.
Reset to default:
1. Unplug the power cord from the wall outlet.
2. Set the ON / OFF switch on the CONTROL PANEL to OFF.
3. Wait 5 minutes.
4. Check the chimney to make sure no vents are blocked or clogged. If they are, use a
vacuum to clean the vents.
5. With the POWER switch turned off, plug the power cord back into the wall outlet.
6. If the problem persists, have the outlet checked by a specialist.
Remote control: battery information
This remote control uses two AAA batteries (not included).
Instructions for battery installation are located on the battery compartment of the remote
control.
Care and Maintenance
Cleaning
Metal:
• Use a soft, slightly damp cloth
• Never use brass polish or household cleaners as they damage the metal.
Glass:
• Use glass cleaner and dry carefully with a paper towel or a lint-free cloth.
• Do not use abrasives or cleaning agents that could damage the surface
Plastic:
• Use glass cleaner and dry carefully with a paper towel or a lint-free cloth.
• Do not use abrasives or cleaning agents that could damage the surface
ALWAYS turn off the fireplace and unplug the power cord
cleaning, changing light bulbs, or moving the electric fireplace.
Otherwise there is a risk of electric shock, fire or injury.
Never immerse in water or rinse with water. Otherwise there is
electric shock, fire or injury.
before
a risk of
55