Door Reversal Instructions; Door Handle - Silhouette Professional DAR055D2BSSPRO Manuel Du Propriétaire

OPERATING INSTRUCTIONS

DOOR REVERSAL INSTRUCTIONS

If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Open the door to a 90° angle and remove the
two screws from the door axis. Slide the bottom
of the door outward to remove it from the
chassis Remove the hinge hole cover from the
top left side of the door and install on the right
side.
2. Remove the upper right hinge.
3. Remove the screw hole covers from the top left of
the chassis and install the upper right hinge. Put
the screw hole covers in the screw holes on the
right side of the chassis.
4. The lower left hinge is pre-installed on the
chassis. Remove the door support from the lower
left hinge and install on the lower right hinge.
5. Install the door on the upper left hinge and
attach the door to the lower left hinge using the
door axis. Before tightening the screws ensure
that the top of the door is level with the top of
the chassis, that the actuator is making contact
with the light switch at the bottom of the chassis
and that the rubber gasket is making a good
seal with the cabinet all the way around.
6. Move the door handle from the left side of the
door to the right side.
1. Hinge Hole Cover

2. Door Handle

3. Actuator
4. Screws
5. Door Axis
6. Upper Right Hinge
7. Upper Left Hinge
8. Lower Left Hinge
9. Door Support
1
2
3
4
5
7
1
2
5
4
3
6
4
4
7
9
8