Maintenance Schedule - Hurricane HAKS-I-4035 Notice Originale

EN ENGLISH
Replacing the guide bar and saw chain
WARNING
Wear protective gloves.
A dull or improperly sharpened chain can cause
excessive motor speed during cutting which may
result in severe motor damage.
Failure to replace or repair a damaged chain can
cause serious injury.
The saw chain is sharp. Always wear protective
gloves when performing maintenance to the chain.
Inspecting and cleaning the chain
brake
Always keep the chain brake mechanism clean by lightly
brushing the linkage free from dirt.
Always test the chain brake performance after cleaning..
Refer to "Checking and operating the chain brake"
section in this manual for additional information.
DISPOSAL
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Please dispose of the device itself at an according
collecting/recycling point. By doing so, plastic and
metal parts can be separated and recycled. Information
concerning the disposal of materials and devices are
available from your local administration.
Batteries are not to be put into the rubbish. As a
consumer you are legally obliged to return used batteries
WARRANTY
For this tool, the company provides the end user -
independently from the retailer's obligations resulting
from the purchasing contract - with the following
warranties:
The warranty period is 60 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts, rechargeable batteries and defects caused
by the use of non fitting accessories, repair with parts that
are not original parts of the manufacturer, use of force,
44
HURRICANE_HAK-S-I_Kettensaege_2x20V_1-3.indd 44

Maintenance schedule

Daily check
Bar lubrication
Chain tension
Chain sharpness
For damaged parts
For loose fasteners
Chain brake function
Guide Bar
Complete saw
Replacement parts (Bar and chain)
Chain
Guide Bar
Chain must be fitted with bar from the same
manufacturer according to above combinations.
and accumulators. At the end of the duration of your
apparatus, the batteries or accumulators have to be
taken from the apparatus, disposing of them separately.
You have the possibility of delivering your old batteries
and accumulators to the local collecting points of your
municipality or to your dealer or to the distribution
centers.
Dispose of the batteries when discharged. We
recommend applying an adhesive tape on the poles
to protect them against short circuit. Never open the
battery.
strokes and breaking as well as mischievous overloading
of the motor are excluded from this warranty. Warranty
replacement does only include defective parts, not
complete devices. Warranty repair shall exclusively
be carried out by authorized service partners or by
the company's customer service. In the case of any
intervention of not authorized personnel, the warranty
will be held void.
All postage or delivery costs as well as any other
subsequent expenses will be borne by the customer.
Before each use
Before each use and
frequently
Before each use, visual
check
Before each use
Before each use
Before each useInspect
and clean
Before each use
After each use
71300292
71300293
20.06.19 15:00