Warn 90288 Guide D'installation Et Operateur page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
STEP 2: MOUNT THE RECEIVER
What is the receiver?
The receiver is a vital safety component of your wireless winch
system. It disconnects the winch from its power source when the
ATV is not in use. The receiver must be correctly installed to work
WAR N I N G
properly.
The receiver should be mounted in a location that is as clean and
TO PREVENT SERIOUS INJURY OR DEATH
dry as possible while also allowing access to the programming
FROM EXPLOSION:
button. The mounting location must also be within two feet of
• Do not drill into gas tank.
the contactor location.
• Verify the area is clear behind the
Best locations for the receiver will vary depending on the ATV.
mounting location before drilling.
Ensure the selected location does not collect or retain water and
the mounting of the receiver does not block drain holes. The
receiver can be attached to a frame tube of the ATV, typically
near the rear storage box or under the seat.
Mounting Steps:
1. Determine the mounting location.
2. If mounting on a frame tube, attach using the wire ties
supplied as shown in figure below.
3. If mounting in vehicle chassis, attach using wire ties supplied.
Programming LED
Programming button
WAR N I N G
TO AVOID SERIOUS INJURY OR DEATH
FROM ELECTRICAL FIRE:
• Never route electrical cables:
- Across any sharp edges.
- Through or near moving
parts.
STEP 3: ROUTE THE HARNESS
- Near parts that become
hot.
Locate the BLACK and GREEN wires running from the contactor
• Always insulate and protect all
to the handlebar switch. Find the bullet connectors on these
exposed wiring and electrical
wires located near the contactor.
terminals.
Plan a route for the wire harness between the receiver and these
bullet connectors.
6
STEP 4: CONNECT THE WIRING
WARNI NG
Note: Refer to Figure 1.
TO AVOID SERIOUS INJURY OR DEATH
1. Pull apart the bullet connectors on the BLACK and GREEN
FROM ELECTRICAL FIRE:
• Never route electrical cables:
- Across any sharp edges.
2. Connect the BLACK and GREEN wires to the same color wires
- Through or near moving
parts.
3. Connect the BLACK ground wire with the ring terminal to the
- Near parts that become
hot.
• Always insulate and protect all
4. Using a test light, locate a switched accessory wire attached
exposed wiring and electrical
terminals.
5. Splice the RED wire to the key controlled accessory wire using
6. Use tie wraps to secure the wire harness
Use a test light to locate an
accessory circuit wire.
Green
Black
Figure 1: Wiring Installation Diagram
wires identified in Step 3 above. These will be located near
the contactor
on the wire harness as shown on the wiring diagram.
contactor as shown.
to the ATV ignition system. The wire should only have power
when the key is in the "ON" position.
the provided wire splice.
Black
Green
Black
Red
7

Publicité

Table des Matières
loading

Table des Matières