Safety Instructions - FAURE FSG25224 Notice D'utilisation

• The appliance should be cleaned regularly and any food deposits removed.
• Failure to maintain the appliance in a clean condition could lead to deteriora-
tion of the surface that could adversely affect the life of the appliance and
possibly result in a hazardous situation.
• The temperature of accessible surfaces may be high when the appliance is
operating.
• The microwave oven shall not be placed in a cabinet unless it has been tes-
ted in a Cabinet.
• The rear surface of appliances shall be placed against a wall.
• Pay attention to the minimum dimensions of the cabinet (if applicable). Refer
to the installation chapter.
• The appliance must be operated with the decorative door open (if applicable).
• Do not use harsh abrasive cleaners or sharp metal scrapers to clean the
glass door since they can scratch the surface, which may result in shattering
of the glass.
• If the supply cord is damaged, it must be replaced by the manufacturer, an
authorized Service or similarly qualified persons in order to avoid a hazard.

Safety instructions

Installation
Warning! Only a qualified person must install this
appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied with the ap-
pliance.
• Always be careful when you move the appliance be-
cause it is heavy. Always wear safety gloves.
• Do not pull the appliance by the handle.
• Keep the minimum distance from the other applian-
ces and units.
• Make sure that the appliance is installed below and
adjacent safe structures.
• The sides of the appliance must stay adjacent to ap-
pliances or to units with the same height.
4
Electrical connection
Warning! Risk of fire and electrical shock.
• All electrical connections should be made by a quali-
fied electrician.
• The appliance must be earthed.
• Make sure that the electrical information on the rating
plate agrees with the power supply. If not, contact an
electrician.
• If the appliance is connected to the socket via an ex-
tension cord, make sure the cord is earthed.
• Make sure not to cause damage to the mains plug
and to the mains cable. Contact the Service or an
electrician to change a damaged mains cable.
• Do not pull the mains cable to disconnect the appli-
ance. Always pull the mains plug.