Applications; Conformity And Approval; Inserting Batteries - Monacor ATS-10R Mode D'emploi

3 Applications

In combination with one receiver or several receiv-
ers of the type ATS-10R and a transmitter ATS-10TM,
a wireless 16-channel audio transmission system
operating in the frequency range of 863 – 865 MHz
can be set up. The system is ideally suited for appli-
cations where the signal of a single audio source
is to be fed to several persons, e. g. guided tours or
multilingual lectures.

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the receiver ATS-10R and the transmitter ATS-10TM
comply with the directive 2014 / 53 / EU. The EU dec-
larations of conformity are available on the Internet:
www.monacor.com
The units are generally approved for operation in
EU and EFTA countries. The operation of the units is
licence-free and requires no registration.

4 Inserting Batteries

1) Slightly press the grooves on the battery com-
partment cover (11) while pulling the cover
downwards at the same time.
2) Insert two 1.5 V batteries or rechargeable 1.2 V
NiMH batteries of size AA with the positive and
negative connections as printed in the compart-
ment.
3) Replace the cover and make sure it en gages.
Never put batteries in the household
waste. Always dispose of the batteries
in accordance with local regulations.
Hint: For quick and easy charging of the recharge-
able batteries used in ATS-10R and ATS-10TM,
MONACOR offers special chargers:
– charging station ATS-10PS for charging the bat-
teries of up to 2 units at the same time
– charging case ATS-12C for charging the batteries
of up to 12 units at the same time
8
– charging case ATS-30C for charging the batteries
of up to 30 units at the same time
5 Connections
On each unit, screw the supplied antenna (5) into
the threaded jack ANT. (1).
Transmitter: The integrated microphone (7) or the
supplied tie clip microphone may be used. When
using the tie clip microphone, connect it to the jack
MIC. (2) [the integrated microphone is switched off
in this case]. Place the supplied windshield on the
tie clip microphone. Fasten the microphone to your
clothes (e. g. tie, lapel) via its clip.
Receiver: The sound can be reproduced via the in-
tegrated speaker (7) or via the supplied earphone.
When using the earphone, connect it to the jack
EAR. (2) [the speaker is switched off in this case]
and attach the earphone to your ear.
6 Operation
1) With the channel selector switch CHANNEL SE-
LECT (10) on the transmitter, select the channel
for transmission from the 16 transmission chan-
nels: Use a narrow object, e. g. screwdriver, to set
the switch to one of the 16 positions.
Example:
In this switch position,
channel 1 is selected.
On the receiver(s), set the switch CHANNEL SE-
LECT (10) to the same channel.
2) Switch on the transmitter: Set the sliding
switch (3) to ON. (In the mid-position STAND BY,
the transmitter is also switched on but it is mute,
i. e. no sound is transmitted.) After switching on,
the LED BATT. LOW (4) briefly flashes in red be-
fore permanently showing green.
Switch on the receiver(s): Set the sliding
switch (3) to ON. (In the mid-position STAND BY,
the receiver is also switched on but it is mute,
i. e. no sound is reproduced via the speaker or