Operation - Follett ITS500-31 Manuel D'installation, D'utilisation Et D'entretien

Reinstalling door assembly
1. Reinstall lower door assembly in bin opening.
2. Reinstall three or four (3 or 4) screws in hood at top of door assembly.
3. Reinstall SmartGATE in side panel tracks and push down to seat.
4. With door closed insert one door stud through hinge bracket.
Note: For proper operation the access door must be reinstalled in the closed position.
5. On other side, insert screwdriver between door and hinge bracket and gently push against bracket to provide
room for door stud to clear bracket.
6. Reinstall washers and screws in lift door and tighten.
7. Check door to ensure proper operation.
Ice guide adjustment
Some ice types are very "slippery" and may fl ow over sides of cart when exiting hopper. Ice guides hang down below
hopper and help contain fl owing ice inside cart.
Guides are installed in highest position at factory, providing 3/4" clearance to top of cart when legs are in full
down position. If legs are adjusted up during leveling of Ice Transport System, ice guides should be lowered to
maintain 3/4" (19mm) clearance. Access to sides of Ice Transport System is required to perform operation.
To reposition ice guides after legs have been adjusted:
1. Position cart (with totes, if so equipped) in bay below shutter door opening.
2. Determine amount guides must be lowered to maintain 3/4" (19mm) clearance.
3. Remove thumbscrews holding guides.
4. Select hole to reposition guide at proper level and resecure with thumbscrew.
5. Repeat process for each bay in system.
brackets on underside of hopper to which
ice guides are secured

Operation

Cart drain operation
1. Position cart all the way in bay.
2. Lock caster to prevent cart movement.
3. To open drain, pull knob out.
4. To close, push knob in.
PUSH TO CLOSE
Cart lids
1. Hang cart lids on brackets on bin side when carts positioned in bay.
2. Remove from bracket and place lid on cart when transporting ice.
3. To avoid placing lid on fl oor, position lid horizontally on cart lip, resting lid against cart handle when unloading ice
from cart.
4. Reinstall lid in bracket on side of bin before placing cart in bay.
6