Manual Mode - Rothenberger Industrial 072990E Mode D'emploi

MANUAL MODE

- Pull the cleaning coil (3) out of the plastic
housing (5) and insert it into the pipe until
you reach the blockage (resistance).
To allow the cleaning coil to move
forward, and at the same time preventing
it from bending or getting twisted, use the
locking wheel (4) to secure it so that there
is a distance of 30 cm between the pipe
opening and the cleaning coil's locking
wheel.
- Use the handle (6) to ensure a secure grip
and turn the crank handle (1) clockwise
until you feel the blockage resistence
lessening.
- Once the locking wheel has reached
the pipe opening, loosen it and unwind
more of the cleaning coil so that the
30cm distance between pipe opening
and the locking wheel can be maintained.
Then secure the locking wheel again.
Repeat this process until the blockage is
removed.
- When you have finished, gradually
remove the cleaning coil from the pipe,
clean thoroughly and manually re-insert
into the plastic housing.
USING A DRILL
Before using a hexagonal adaptor
(2) to connect the cleaning coil to a
drill, make sure the crank handle (1) is
removed.
072990E_Anleitung.indb 8
4
3
1
6
8
31.03.15 13:17