Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Doors
F3b Phillips-head screw (12)
IMPORTANT:
The door with the lock assembly (P7) should be installed on the
right-hand side of the cabinet.
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start Phillips-head screws (F3b) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle screws through the door hinge into the cabinet
and hand tighten.
P2
P5m
P7
P1
P5
A
P5m
P3
A. Phillips-head screws
B. Door closure magnets
4. Repeat steps 2 and 3 to attach the left-hand door (P6).
5. Align the doors and completely tighten the door screws.
6
F3b
B
Complete Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
NOTE: The back panels may have additional holes along the
sides that are not used.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs. Turn to the
left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.
ACCESSORIES
To order the accessories listed below or to inquire about other
available accessories call 1-866-342-4089 or contact your
authorized Gladiator brand dealer.
In Canada, call 1-800-807-6777.
Mounting Bracket Kit -To mount the cabinet on Gladiator
Garageworks GearWall
®
panels or GearTrack
Order Part # GABK362PSS
®
®
channels.
Publicité
Table des Matières
