Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cabinet Use Requirements
Intended for use in a garage.
Maximum weight limit is 50 lbs (22.7 kg) for each shelf.
Maximum weight limit is 300 lbs (136 kg) for the cabinet.
Unpack Cabinet Parts
1. Remove and verify the contents. Contents include an Allen
wrench, a key, and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.
Assemble Cabinet
F1 ⁵⁄₁₆ " Allen-head bolt (16)
Gather the required tools before starting installation.
Tools Needed:
¹⁄₂" Wrench
Phillips screwdriver
Tools Supplied:
Allen wrench
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
As you assemble the cabinet frame, make sure the edges with
the loops are facing up.
The cabinet top (P2) is intentionally designed so that the tabs will
match with the loops on the sides only when it is positioned
correctly. If the tabs on the cabinet top do not match up with the
loops on the side panel (P1), turn the cabinet top around.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the loops is facing up as shown.
2. Align the tabs in the cabinet top (P2) with the loops in the cabinet
side (P1). Slide the cabinet top between the edges of side panel.
NOTE: Make sure each tab is inserted fully behind the loop.
3. Align the two holes in each corner. Using Allen-head bolts (F1),
fasten the side panel (P1) to the top (P2) as shown. Do not
tighten completely.
4. Repeat steps 2 and 3 for the other cabinet side (P1).
ASSEMBLY INSTRUCTIONS
F1
Level
Key
5. With the smooth side toward the cabinet interior, align the four
tabs in the cabinet bottom (P3) with the loops in the cabinet
sides (P1). Slide the cabinet bottom between the edges of side
panels.
NOTE: Make sure each tab is fully inserted behind the loop.
P1
P3
P1
P3
6. Align the two holes in each corner. Using Allen-head bolts (F1),
fasten the side panels (P1) to the bottom (P3) as shown. Do not
tighten completely.
Attach Back Panels
F3b Phillips-head screw (34)
IMPORTANT: Attach the back panels starting at the top of the
cabinet with back panel (P8) and working down to the cabinet
bottom. Each back panel will overlap the panel below.
1. Align the tabs in back panel (P8) with the loops in the top (P2)
and sides (P1) of the cabinet.
2. Slide back panel (P8) toward the cabinet top (P2) until the back
panel is firmly in place.
NOTE: Make sure each tab is inserted fully behind the loop as
shown.
3. Slide back panel (P9) upward until the top of panel (P9) is under
back panel (P8) and the tabs are inserted in each loop.
NOTE: Each back panel will slightly overlap the panel below.
4. Repeat Step 3 to assemble the remaining back panels ending
with back panel (P10).
5. Using Phillips-head screws, attach each back panel to the panel
below.
6. Using Phillips-head screws, attach panel (P8) to the cabinet top
(P2) and panel (P10) to the cabinet bottom (P3).
P2
P1
P3
F3b
P1
3
Publicité
Table des Matières
