Connecting The Usb Cable - Pioneer BDR-X12UBK Mode D'emploi

Connecting the USB cable

This is a hot-plug unit. Connect the unit to the supplied USB cable.
1 Confirm that your computer (PC) has available USB port.
2 With your Windows or Mac operating system running, use the supplied USB cable to connect this
unit to the PC.
Caution
• Do not disconnect the USB cable during data transfers.
• Do not disconnect the USB cable during the PC start nor any operation with the unit.
Note
• It is recommended to connect to USB 3.0 port or above, , since when a USB 3.0 cable is connected
to a USB 2.0 port, the connection will be limited to USB 2.0 performance standards.
• This unit can operate with USB 1.1 but will not provide optimum performance.
• Connecting this unit through a USB HUB or using unspecified cables may not guarantee proper
operation.
• The unit will not run on power supplied from the USB connector (bus power). Be sure to use the
unit with the AC adapter supplied with the unit connected.
14
En
USB Type-A
(USB 3.0 or higher
is recommended)
USB cable (accessory)
USB Type-B