Hama DR1500BT Mode D'emploi page 5

Warning
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• Disconnect the product from the network using the
power button – if this is not available, unplug the
power cord from the socket.
Note – Switching on for the first time
• The radio switches on automatically with the greeting
(F1) in DAB mode and first of all sets the time
automatically. This may take several seconds.
• The radio then runs the Auto Scan function.
• During Auto Scan the display shows the message
‚Scanning...', a progress bar and the number of
stations currently found. (F2)
• After the Auto Scan process has completed turn SCROLL/
OK ► II to select a station that you want to listen to from
those found.
• Press SCROLL/OK ► II to listen to your chosen station.
Note – Auto Scan
• If Auto Scan is unable to find any stations, switch the
radio to the Tune Select menu.
• Turn SCROLL/OK ► II to choose between Manual
Tune or Auto Scan.
• Press SCROLL/OK ► II to confirm your choice.
Note – Alarm function features
It is not necessary to set the time on the radio and in fact
not even possible as the radio receives the local time via
the DAB signal and sets itself automatically accordingly.
However, this is not always possible in FM mode as time
data is not transmitted by all stations on that frequency.
Note – Alarm function features
• The DAB radio offers two alarm times that can be set
individually.
• The alarm can be set to a ring tone or to a previously
tuned radio station (DAB/FM)
5.1 Setting the alarm time and type
• Press ALARM to open the Alarm menu.
• Use SCROLL/OK ► II to select Alarm 1 or 2.
• Press SCROLL/OK ► II to confirm your choice.
• Press SCROLL/OK ► II again and use SCROLL/OK ► II to
choose the Alarm Setting menu item.
• Press SCROLL/OK ► II to confirm your choice. The hour
shown on the display flashes and can be set (F10).
• Turn SCROLL/OK ► II to set the hour of your desired
alarm time.
• Press SCROLL/OK ► II to confirm your setting.
• Then turn SCROLL/OK ► II to set the minute of your
desired alarm time.
• Press SCROLL/OK ► II to confirm your setting. After
saving the minute the alarm time is saved and you are
automatically taken to alarm type settings.
• Turn SCROLL/OK ► II to choose the preset (see section
6.7) DAB or FM station that you want to wake up to
(F11).
• Press SCROLL/OK ► II to save your setting.
• Turn SCROLL/OK ► II to choose the ring tone (1 or 2) for
the alarm.
• Press SCROLL/OK ► II to save your setting.
• Turn SCROLL/OK ► II to adjust the volume of the alarm
(1 - 20) with which you want to be woken up (F10).
• Press SCROLL/OK ► II to save your setting.
Note
• Repeat the complete process for the other alarm (1 or
2) if desired.
3