Parts Included; Installation Procedure; Installing A Wall-Mounted Unit - Hatco SAL Série Manuel D'installation Et D'utilisation

English
8. level the unit by turning the leveling feet on each leg, if
necessary.
9. Install the drip tray and cooking grate.
10. For corded units, plug the unit into a properly grounded
electrical receptacle of the correct voltage, size, and plug
configuration. See the SPECIFICaTIONS section for details.
11. For non-corded units, have a qualified electrician install a
hardwired connection between the unit and the on-site
electrical system (refer to "Hardwired Connection" in this
section for additional information).
Countertop
18"
(46 cm)
Non-Combustible
Construction
minimum Distance Requirement

Installing a Wall-Mounted Unit

mounting the unit on a wall requires special considerations and
procedures due to the weight of the unit. Follow the guidelines
below when determining the location for wall mounting as well
as during installation.
• The wall brackets must be fastened to a wall with 16"
(406 mm) on center, solid wood 2x4 stud construction
covered by a minimum of 1/2" (13 mm) thick sheathing.
• The wall bracket must be installed with four 1/4" x 2-1/2"
(6 x 64 mm) lag screws that solidly hit the wood studs in
the wall.
• locate the unit directly underneath an exhaust hood if
possible. This will ensure total suction of steam produced
during cooking.
• make sure the unit is installed where the ambient air
temperature will not rise above 113°F (45°C) and where it will
not be exposed to excessive moisture or grease-laden air.
• make sure the unit is at the proper height in an area
convenient for use.
Form No. Salm-0915
2" (51 mm)
18"
(46 cm)
12"
(30 cm)
Top View

Parts Included

The following parts are included with wall-mounted units.
Item
Wall Bracket
mounting Clip
1/4" x 2-1/2" (6 x 64 mm)
lag Screw
Hex Screw

Installation Procedure

Use the following procedure to install a wall-mounted unit.
1. make sure the mounting location meets the requirements
listed previously in this procedure.
2. Determine the height for the unit installation.
• mark the wall at the desired height for the top of the unit.
NOTE: The top of the wall bracket is approximately 1-1/2"
(38 mm) inches above the top of the unit after
installation.
3. locate the wood stud positions in the wall.
• Determine which studs to use for installation. The studs
used must allow the wall bracket to be installed with the
mounting holes a distance of 16" (406 mm) on center
from each other.
4. Install the wall bracket onto the wall.
a. Center and level the wall bracket on the desired studs.
mark the locations for the four lag screws through the
holes in each side of the bracket.
b. Drill four 3/16" (5 mm) pilot holes in the wall at each
marked location for the lag screws. The lag screws are
1/4" (6 mm) in diameter and 2-1/2" (64 mm) long.
c. Insert four lag screws through the wall bracket and into
the pre-drilled pilot holes in the wall.
d. Tighten each lag screw securely.
1/2" (13 mm) Sheathing
Lag Screw
attaching the Wall Bracket
7
INSTALLATION
Quantity
1
2
4
4
3/16" (5 mm)
Pilot Holes
2x4 Wood 2x4 Wood
Studs 16" Studs 16"
(406 mm) (406 mm)
On Center On Center
Wall Bracket
continued...