Perel AOBD2 Mode D'emploi page 5

If the code retrieved is a pending code, PD will be displayed.
To view previous codes, press SCROLL to scroll through the list until the first code is displayed.
8. Refer to the list of DTCs on the last pages of this manual.
6.2 Erasing Codes
Erasing the DTCs allows the code reader to delete not only the codes from the
vehicle's on-board computer, but also manufacturer-specific data. Further, the
I/M Readiness Status for all vehicle monitors is reset to Not Ready or Not
Complete. Do not erase the codes before the system has been checked by a
1. If you decide to erase the DTCs, select ERASE and press ENTER.
If the code reader is not connected or no communication is established with the vehicle, then refer chapter
6.1 Reading Codes, steps 1 to 6.
2. Press Yes to erase or No to cancel.
3. If the codes are successfully cleared, ERASE DONE will be displayed. Press ENTER to return to the main
menu.
V. 01 – 07/02/2017
AOBD2
WARNING
professional technician.
5 ©Velleman nv