SEVERIN KM-3885 Mode D'emploi page 11

- For safety reasons, use the pestle at all
times when feeding the ingredients into
the food chute. During operation, the
pestle should remain inserted.
- Short-term operation
When using the kneading function,
please note that the appliance is
designed for short-term operation only,
i.e. the unit must not be operated for
more than 3 minutes at a time. Switch
off the appliance afterwards and allow
sufficient time for it to cool down before
resuming operation.
Operation settings
- Start the kneading process at speed
level I. Once the dough has reached a
firmer consistency, continue kneading at
speed level II.
- The dough is ready once it has formed
into a ball.
C. Slicing and shredding/grating
- Attach the bowl.
- Place the drive shaft extension firmly on
the drive shaft in such a way that the
extension almost touches the bottom of
the bowl.
- Hold the insert mounting with the
grating surface facing up.
- First fit the L-shaped edge of the
selected insert (slicer or grater) into the
side of its mounting.
- Now press the opposite side of the insert
into the mounting.
(To remove the insert, push it up from
below on this side until it comes free
from the mounting.)
- When properly inserted, the upper
surface of the insert must be flush with
the surface of the disc.
- Fit the insert mounting with the grating
plate inserted onto the shaft extension.
- Place the lid on the bowl and turn it
clockwise to lock (
turn the bowl clockwise to lock it (
- Place the small safety lid on the blender
mounting. Ensure that the recess on the
small lid is properly fitted over the
). Afterwards
).
11
corresponding protrusion on the main
lid of the bowl before turning it
clockwise to lock it.
- For safety reasons, use the pestle at all
times when feeding the ingredients into
the food chute. During operation, the
pestle should remain inserted.
- Always switch the appliance on before
feeding the ingredients into the food
chute.
- Do not put in more than 1 kg of food.
When processing larger quantities, the
bowl must be emptied from time to
time.
Functions and operation settings
- The slicer can be used for slicing
cucumber, potatoes, carrots etc.
- For grating cabbage, carrots or celery
etc, the grater should be used.
- With these applications, always start
processing at speed level I. If necessary,
the process may be repeated at speed
level II.
D. Blender
- Place the large safety lid on the bowl
mounting and turn it clockwise to lock
it.
- Place the blender jar on the blender
mounting and turn it clockwise to lock
it.
- Put in the liquid ingredients, then put
the blender lid in place and lock it
clockwise.
- After processing, switch off the
appliance and remove the blender jar by
slightly turning it anti-clockwise and
lifting it off.
Caution: Do not let the unit run dry (i.e.
without any contents).
Do not fill to more than the indicated
maximum of 1 litre of liquid.
Caution: do not fill with hot liquids.
Operation settings
- Operate the blender unit with the main
switch set to the P-position (Pulse).
- Short-term operation: