Declaration of Conformity
We declare under our sole responsibility that this product
is in conformity with the following standards of standard-
ization documents:
DIN EN 1037, EN ISO 12100, DIN EN 62841-1,
DIN EN 55014-1, DIN EN 55014-2
according to the provisions of the:
2006/42/EC, 2014/30/EU, 2014/35/EU.
Dipl.-Ing. (FH) Dieter Hammel
Authorised to issue this declaration and for the gathering
of the technical documentation.
01.02.2020
i.v.
Uzin Utz Tools GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1
Technical data
Supply voltage charger ...................120/230V 50 / Hz AC
Battery voltage .......................................................... 18 V
Battery capacity ........................................................ 5 Ah
Speed idling .... ................................................ 8,500 rpm
Weight with battery LS35 ......................................... 6 kg
Weight with battery LS65 ......................................... 7 kg
Working width LS35 ............................................ 3-35 cm
Working width LS65 ............................................ 3-65 cm
Saw blade .......................................................... Ø 105 cm
scope of delivery
1 BATTERY strip cutter 18V
1 charger 230V / 50Hz
2 batteries 18V / 5 Ah
1 dust bag with handle
1 tool set
1 hearing protection
1 saw blade 1 carrying case / box
1 safety glasses
2.0 Safety Warnings
2.1 General Power Tool Safety Warnings
Read all safety warnings and all
Warning
instructions.
Failure to follow the warnings and instructions may result
in electric shock, fi re and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
2.1.1)
Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmosphe
res, such as in the presence of fl ammable liquids,
gases or dust.
Power tools create sparks which may ignite the
Dust or fumes.
c) Keep children and bystanders away while
operating a power tool.
Distractions can cause you to lose control.
2.1.2)
Electrical safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power tools.
Unmodifi ed plugs and matching outlets will reduce
risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of electric shock if your
body is earthed or grounded.
c) Do not expose power tools to rain or wet
conditions.
Water entering a power tool will increase the risk of
electric shock.
EN
14