Resetting The Unit - Denver CRP-717 Mode D'emploi

If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge
(ESD) or a power surge that triggered the internal microcontroller to
shut down automatically. If this occurs, disconnect the AC POWER
CORD from the wall and remove the backup battery from the
compartment. Wait at least 3 minutes, and reinsert the battery for
the back-up, and reattach the AC Cord to the wall. The unit is now
reset, so you will need to setup the unit time and alarms again.
Frequency :
Battery backup :
Power source :
Projection distance: ≤ approx. 90 to 270cm
DENVER CRP-717.indd 8

RESETTING THE UNIT

SPECIFICATIONS
FM 87.5 – 108 MHz
1 x 3V CR2032 flat lithium battery (not included)
AC 230V ~ 50Hz, 5W
ENG-7
15 11 27 9:40