Table des Matières
Publicité
Ground Pin
Figure 1
Terminal de tierra.
Figura 2
Broche de terre
Figura 3
Page -10-
Plate
Screw
Outlet must be
connected to
the electrical
ground
Tornillo de
la tapa
El toma
corriente
debe estar
conectado al
polo de tierra.
Vis de fixation
La prise doit
étre reliée à
la terre.
120 VOLT MACHINE
INSTRUCTIONS FOR CONNECTION
TO THE POWER SUPPLY
AND THE ELECTRICAL GROUND
This machine must be connected to the electrical
ground to protect the operator from electric shock.
The machine has an approved power cord with three
conductors and a plug with three terminals. Connect
the plug to a receptacle that has three holes and is
connected to the electrical ground. The green (or
green and yellow) conductor in the cord is the ground
wire. Never connect this wire to any terminal other
then the ground terminal.
This machine uses a 120 volt AC 60 cycle electrical
circuit. Make sure you have the correct frequency and
voltage before connecting the power cord to an outlet.
The machine has a plug as shown in Figure 1. If a
receptacle connected to the electrical ground as
shown in Figure 1 is not available, have one installed
by an electrical contractor. Do not use an adapter.
WARNING:
To prevent possible electric shock,
protect the machine from rain. Keep
the machine in a dry building.
WARNING:
To prevent possible electric shock,
always use a 3-wire electrical system
connected to the electrical ground.
WARNING:
Do not cut, remove or break the ground
pin. If the outlet does not fit the plug,
consult your electrical contractor.
WARNING:
Have worn, cut or damaged cords and
plugs replaced by an authorized ser-
vice person.
CLARKE TECHNOLOGY Operator's Manual PTV-15
Publicité
Table des Matières
