Velleman VRC1601D Notice D'emploi page 5

b. Direct Setup by Brand and Code
• Turn on the device (e.g. television set) you would like to operate (insert a videotape if it's a VCR).
• Hold the SET key pressed on the VRC1601D and press
the device key (in this example: TV).
• Release both buttons. A random brand will be displayed
on the LCD. Select the correct brand by using the
the button.
• Check the functions of the keys. If none or most of the
keys work, select another code using the
• Press OK to confirm. SUCCES will be displayed on the LCD. Press the device key again to finish the setup or select another setup
option using the or the button.
Remark: - Exit the codes by pressing the EXIT or the device key (in this example: TV).
- If the device is locked, unlock it before setup (see "9.c. Locking the Device").
c. Setup by Auto Search
You may use the auto-search function to find the correct code of the device.
• Turn on the device (e.g. DVD player) you would like to
operate (insert a videotape if it's a VCR).
• Hold the SET key pressed for 3 seconds. SETUPCODE
appears on the LCD. Press OK to confirm.
• AUTO SRCH appears on the LCD. Press OK and select
the device using one of the device keys. Point the
VRC1601D at the device and press OK. The auto-
search function starts.
• If the device reacts press a key to stop the auto-search
function. You can also select a code using the
button. Check the functions of the keys. If none or
most of the keys work, repeat the steps above.
• Press OK to confirm the code. SUCCESS will be
displayed on the LCD. Press the device key again to finish the setup or select another setup option using the
Remark: - When the remote has searched through all the codes, it will stop at the first code.
- If the device is locked, unlock it before setup (see "9.c. Locking the Device").
d. Setup by Entering a Code
• Turn on the device (e.g. television set) you would like to
operate (insert a videotape if it's a VCR).
• Consult the code table at the back of this manual and
find the code corresponding to the brand of the device
(in this example: Lifetec: 003, 010, 062).
• Hold the SET key pressed for 3 seconds. SETUPCODE
appears on the LCD. Press OK to confirm.
• Select ENTERCODE using the
or the
press OK.
• Press the device key corresponding to the device you
want to operate (in this example: TV) and press OK. Enter the 3-digit code (in this example: 003 for Lifetec) and press OK to save.
• The LCD will display SUCCESS. Press EXIT twice to exit the setup mode.
• Check the functions of the keys. If none or most of the keys work, repeat the steps above and try another code (in this example: 010
or 062). Press the device key again to finish the setup or select another setup option using the
6. Learning Function
The learning function is used to supplement the pre-programmed code list. The standard code list may provide most of the functions
needed, but you can add a small number of functions for your remote control or add a new code from a remote control not mentioned in
the code list. Prepare the other remote control from which you will copy the code.
VRC1601D
or
or the button.
or the
button and
5
or the button.
or the button.
VELLEMAN