Power Sources - Panasonic RF-U350 Mode D'emploi

Power sources

The unit can be powered with household AC power or dry cell batteries (not included).
Using a household AC outlet
Connect the AC power supply code firmly to the unit and the outlet.
1
Plug one end of the AC power supply code
(included) into the unit's AC IN socket.
2
Plug the other end into the household AC
outlet.
Note
• The included AC power supply code is for use with this unit only.
Do not use it with other equipment.
Do not use an AC power supply code from any other type of equipment with this unit.
• If you are not going to use the unit for a prolonged time, it is recommended that you unplug the AC power supply code
from the household AC outlet. Power will still be consumed even when the unit's power is not turned on. (Approx. 0.9 W)
Using dry cell batteries (not included)
1
Unplug the AC power supply code from the
unit's AC IN socket.
• When the AC power supply code is connected to the unit,
the unit cannot be powered by the dry cell batteries.
2
Remove the battery cover.
3
Insert six R14/LR14 batteries (not included)
in the numerical sequence.
• Insert the batteries correctly with their "
poles aligned as displayed.
4
Put the battery cover back in its original
position.
Removing the batteries
1
Push the " " side of battery 6 toward its " "
side, and remove batteries 5 and 6.
2
Put your finger into the cutout inside the
compartment, and remove batteries 3, 4, 1
and 2.
Note
• When the charge of the dry cell batteries is depleted, "LOW BATTERY" appears and "
panel.
• After replacing the batteries, set the clock again (
• The registered preset stations (
Register the stations again when using the radio next.
Dry cell battery
• Align the poles (+ and -) properly when inserting the batteries.
• Do not mix old and new batteries or different types of batteries.
• Do not recharge ordinary dry cell batteries.
• Do not heat or disassemble the batteries. Do not allow them to contact flame or water.
• If the unit is not going to be used for a long time or if the unit is to be powered exclusively by AC power, remove the
batteries and store them in a cool dark place.
• Do not keep together with metallic objects such as necklaces.
• Do not use rechargeable type batteries.
• Do not use batteries if the covering has been peeled off.
Mishandling of batteries can damage other items, cause damage to the unit, and may cause a fire through short-circuiting
or electrolyte leakage.
If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any part of your body.
" and " "
page 5).
page 5) will be lost if the batteries have been removed for more than 3 minutes.
Insert the batteries in
numerical sequence
while pushing down on
their " " sides.
Bottom row at the back
Household AC outlet.
(AC 230 V, 50 Hz)
AC power supply code
(included)
" flashes on the display
3
3