Programming; Linking A Mobile Phone - Ksenia ergo A KSI2100030.301 WHITE Manuel D'installation

PROGRAMMING A CODE
A total of 18 codes can be programmed.
In order to program codes please follow the steps below:
1. Enter the 6 digit Installer-PIN on the keypad and confirm with OK. The Installer-PIN
can be found inside the envelope included in the package. ( to preserve )
EN
2. After two ascending tones, the blue backlighting and the red led switch on, the yellow led starts
blinking. That indicates that the programming mode is active.
3. Enter the desired code. The code can contain from 4 up to 10 numbers. Confirm
this step with OK.
4. If the code has been succesfully saved, two ascending tones are played, the blue
backlighting and the green led blink for a while, and the relay commutates.
5. The programming mode is automatically closed.
DELETING A CODE
In order to delete a code please follow the next steps:
1. Enter the 6 digit Installer-PIN on the keypad and confirm with OK. The Installer-PIN
can be found inside the envelope incuded in the package.
2. After two ascending tones, the blue backlighting and the red led switch on, the yellow led starts
blinking. That indicates programming mode is active.
3. Enter the code you wish to delete and press OK to confirm.
4. If the code has been succesfully deleted, three ascending tones are played, yellow
led and red led blink for a while.
5. The programming mode is automatically closed.

LINKING A MOBILE PHONE

A total of 6 Bluetooth devices can be programmed.
In order to link a Bluetooth device compatible ( mobile phone ) with
1. Activate Bluetooth on your mobile.
2. Enter the 6 digit Installer-PIN on the keypad and confirm with OK. The Installer-PIN
can be found inside the envelope included in the package.
3. After two ascending tones, the blue backlighting and the red led switch on, the yellow led starts
blinking. That indicates programming mode is active.
4. Search within the Bluetooth settings of your mobile for device "Ksenia
select it.
5. Connect your mobile to "Ksenia
6. If the mobile phone has been succesfully connected two ascendent tones are played,
the blue backlighting and green led blink for a while, the relay commutates.
7. The programming mode is automatically closed.
NOTE: in order to delete a mobile phone, factory default must be performed.
12

PROGRAMMING

A" using the 6 digit Installer-PIN.
ergo
A , please follow these steps:
ergo
A" and
ergo