Ducane 20529917 Guide De L'utilisateur page 18

Du barbecue au gaz naturel
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM
IGNITION SYSTEM
MAIN GRILLING BURNERS
ROTISSERIE BURNER ELECTRONIC
IGNITION
BURNERS WITH POOR FLAME
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.ducane.com.
18
CHECK and CURE
Be sure that there is gas fl ow to the burners by attempting to match light your burners.
If match lighting is successful, the problem lies somewhere in the ignition system and
will need to be checked.
CAUTION: Always turn the gas supply off at the main gas
cut off before proceeding with any troubleshooting proce-
dures.
If, for any reason, the snap ignition fails to ignite the main grilling burner(s), repeat the
lighting procedures described on the grill control panel.
WARNING: The hood must be in the full open position any
time you attempt to light your grill. Failure to open the
hood could lead to delayed ignition resulting in bodily
harm.
After shutting off the main gas supply, remove the cook grate and heat distribution
plates. Turn snap igniter counter clockwise and check if the electrode is sparking to the
igniter tube. Try the snap igniter several times.
With a fresh battery installed, push electronic ignition button and check if there is a
spark between the two electrode tips. There needs to be a 1/8" to 3/16" gap between
the electrode tips. If the gap is lesser or greater, carefully bend the electrode tips until
you have the correct gap of 1/8" to 3/16"(A).
Check to be sure burner ports, shutter, end of the burner (venturi) and orifi ce(s) are
free of any obstructions. Also, if your grill has been stored over a prolonged period of
time, check to make sure no spiderwebs have been formed in the shutter end of the
burner (venturi) or over orifi ces.
A
IMPORTANT
If the main burner(s) still fails to ignite, make
sure that there is gas fl owing to the burner(s)
by attempting to match light the burner(s).
If the burners will match light, then proceed
with the ignition checkout.
If for any reason the igniter system is still
inoperative, follow match lighting instructions.
Verify that the battery is in good condition
and installed correctly. If so, try a new battery.
If for any reason the igniter system is still
inoperative, follow match lighting instructions.
If you still have a poor fl ame, please contact
dealer for futher assistance or call Customer
Service
www.ducane.com

Publicité

Table des Matières
loading

Table des Matières