HAEGER Precision II HC-03W.005A Mode D'emploi page 7

NOTE: After cleaning and the appliance has been used for approx. 20 minutes, put a
few drops of lubricating oil between the trimming comb and the trimming blade and
then switch the appliance briefly on to ensure that the oil is well and evenly
distributed. Regular oiling will guarantee good cutting performance over a long
period and thus a long service life.
Oiling the shaving head
Oil the shaving head from time to time if you use the trimmer regularly. Use non-
corroding oil, for example sawing machine oil.
1. Remove the comb attachment used.
2. Apply one to two drops of oil between the cutting teeth.
3. Turn the trimmer briefly on and then off again to distribute the oil.
4. Remove any excess oil by wiping with a cloth.
Replacing the shaving head
Only use original accessories. Accessories such as the shaving head, mains
•
adaptor and comb attachment are available at specialist shops. Never attempt
to sharpen the shaving head yourself. Switch the trimmer off!
Change the shaving head as described in "Cleaning and care".
•
If the power becomes weak after a brief period
Load the rechargeable battery pack, if necessary operate the trimmer with the
•
mains adaptor.
If the trimmer pulls on hair
Clean and oil the shaving head or replace with a new one.
•
T D
ECHNICAL ATA
Model:
Power supply adaptor:
Protection class power adaptor:
Motor voltage:
Charging time:
Fully charged run time:
Battery capacity:
For home use only
Instructions for use
HC-03W.009A
Input : AC 100-240V 50/60Hz
Output : 3V 600mA
Class II
DC 2.4V
8 hours
45 min
2x 1.2V Ni-MH AA 600mAh
English
5