Care And Cleaning - HAEGER Precision II HC-03W.005A Mode D'emploi

English
To cut the HAIR EVENLY, allow the clipper ADVANCE SMOOTHLY through the
•
hair. Do not attempt to force it.
It is better to cut a little than too much. Begin with the maximum cutting length
•
position (16 or 30 mm).
We recommend that you make a note of the cutting level selected each time, so
•
that you can repeat the same hairstyle on other occasions if you wish.
G
UIDE COMB
Use the guide comb to shorten hair evenly to a length of 4 -16mm or 18-30mm.
To set the desired length, rotate the cutting length control wheel.
Shaping the beards and shaving the buck of the neck is done without attachments.
1. Remove the attachment.
2. Draw the cutting head at a low angle along your skin without applying pressure.
C C
ARE AND LEANING
It is essential to switch off the unit and remove the main adaptor from the wall
•
socket before cleaning and oiling.
To avoid the risk of electric shock, the appliance must not be immersed in liquid
•
or even allowed to come into contact with liquid.
Do not use abrasives or harsh cleaning solutions.
•
If necessary, the housing may be wiped with a dry, lint-free cloth.
•
Trimming comb and trimming blade
After each use, use the cleaning brush to remove the hair between the
trimming comb and the trimming blade.
1. Remove the comb attachment.
2. Press the shaving head towards the back and remove it.
3. Brush out the shaving head insert (it is the area behind the shaving
head when it has been removed).
4. Reinsert the shaving head by inserting the latch of the shaving
head into the groove of the casing.
5. Press the shaving head back into the casing, until it engages
audibly.
6. Wet/dry design for use in shower and easy cleaning.
4 Instructions for use