Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
M
C
AIN
OMPONENTS
1. Cutting head
3. Detachable comb
5. ON/OFF switch
7. Charging doc
9. Cleaning brush
S
-
HORT
TIME OPERATION
The appliance is designed to be operated for a short period, i.e. the hair trimmer can
be operated without interruption for a maximum of 20 minutes. Operation can be
resumed after the appliance has cooled down for approximately 30 minutes.
C
HARGING YOUR PERSONAL GROOMER
Before using your personal groomer for the first time, charge for 8 hours.
There are two methods to charge the appliance.
Direct connection – connect the adaptor plug directly into the body.
Using charging stand - connect the adaptor plug directly into the charging stand
and then put the appliance into the stand.
1. Ensure the product is switched off.
2. Place your personal groomer into the charging stand, connect the charging
adaptor to the product and then to the mains. The charging indicator will light
up.
3. Run time from fully charged is up to 45 minutes.
4. Your personal groomer cannot be overcharged. However, if the product is not
going to be used for an extended period time(2-3mouths), unplug it from the
mains and store. Fully recharge your personal groomer when you would like to
use it again.
5. To preserve the life of your batteries, let them run out every six months then
recharge for 8 hours.
T
IP AND HINTS CONCERNING USE
We recommend that the hair should be DRY when cutting with the clipper for
•
better control over the amount of haircut.
Use SHORT STROKES. Do not complete a whole side with one stroke.
•
Remember to comb the hair frequently as you are cutting it.
•
Instructions for use
2. Barber comb
4. Cutting length control wheel
6. Indicator light charge control
8. Power adaptor
12. Lubricating Oil (not shown)
English
3
Publicité
Table des Matières
