Noise/Vibration Information - Wiha SPEEDE Guide Rapide

EN
Insert slimVario bit
Insert the Wiha slimVario bit correctly into the speedE's bit chuck . The bit chuck clamps the bit
1 3 3
to the screwdriver handle.
slimVario bit change
Pull out the Wiha slimVario bit to remove. Since the bit is not locked into position separately, it can
1 1
be removed by twisting against the clamp hold.
Note: Use the VDE-tested Wiha slimVario bit system with a 6 mm chuck.

Noise/Vibration Information

Sound emission values determined according to EN 62841. Typically the A-weighted sound pressure level of
the product is 70 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed 80 dB(A). Wear hearing protection!
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 62841. Drilling into
metal: ah<2.5 m/s², K =1.5 m/s² Screwdriving without impact: ah<2.5 m/s², K =1.5 m/s². The vibration level
given in this information sheet has been
measured in accordance with a standardised test given in EN 62841 and may be used to compare one tool
with another. It may be used for a preliminary assessment of exposure. The declared vibration emission level
represents the main applications
of the tool. However if the tool is used for different applications, with different accessories or insertion tools
or is poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is
switched off or when it is running but not actually doing the job. This may significantly reduce the exposure
level over the total working period. Identify additional safety measures to protect the operator from the
effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
24