Top Panel; How To Replace The Fader; Rear Panel - Tascam XS-3 Mode D'emploi

English

2.1. Top Panel

1 MIC LEVEL
Adjusts the MIC input signal level.
2 MIC EQ
2-band EQ for microphone input signal.
3 TRIM
Adjusts the input signal level of each PGM.
NOTE
All input sensitivity adjustment must be done by
very carefully using level meter and/or head-
phones as a reference and avoiding that all the
red LEDs of the level meter light up, otherwise
input could be clipped (overload).
4 PGM EQ
3-band EQ for each PGM signal.
When all EQ are set to -26 dB, the sound will be cut
fully.
5 C.F REVERSE
Sets the direction of CROSS FADER operation.
OFF: Moving the CROSS FADER toward
A makes A signal louder and moving
the CROSS FADER toward B makes
B signal louder.
REVERSE: Moving the CROSS FADER toward
A makes B signal louder and moving
the CROSS FADER toward B makes
A signal louder.
6 C.F CURVE
Allows you to adjust the PGM 2 FADER response
curve from soft (counter-clockwise) to hard (clock-
wise).
7 PHONO/LINE
Selects the input signal (PHONO or LINE) of each
PGM.
8 PGM FADER
Adjusts the PGM level.
9 MASTER LEVEL
Adjusts MASTER OUT 1 (balanced TRS and unbal-
anced RCA connectors) output level.
0 EFFECT switch and LED
Activates the external effect path of MASTER when
EFFECT switch is turned on. When effect path is acti-
vated, LED will light up.
6
TASCAM XS-3
2. Features and controls
q MONITOR MASTER/CUE
Selects the way of monitoring in the headphones.
CUE: This way allows you to monitor the
PGM signals adjusted by cue balance
fader.
MASTER: This way allows you to monitor the
pre MASTER volume signal.
w LEVEL
Adjusts the headphone output level.
e CUE BALANCE
Adjusts the balance between PGM 1 and PGM 2 signal
in the headphones.
r CROSS FADER
Mixes the PGM 1 and PGM 2 signals.
CROSS FADER is user replaceable. It is possible to
set the CROSS FADER curve and reversal.
t INPUT LEVEL METER
Indicates the signal level of each PGM.
NOTE
LEVEL METER indicates the post PGM FADER
signals.

2.2. How to replace the fader

1. Remove the two screws from the fader panel sur-
face.
2. Remove the fader.
3. Unplug the multi-cable connector that connected to
the fader.
4. Plug in the multi-cable connector to a new fader.
5. Replace the fader with the screws.

2.3. Rear Panel

y EFFECT (unbalanced TRS jack)
Inserts the external effect in STEREO OUTPUT signal
path. Connect the external effector to this jack.
Connections are follows:
SEND: Tip
RETURN: Ring
GND: Sleeve