Agri-Fab 45-0309 Notice D'utilisation page 6

19. Place the flow control lever into the slot in the hopper.
See figure 8.
20. Place the center brace into the hopper. Insert the 1/4" x
1-1/4" hex bolt through the center brace and the front of
the hopper. Assemble a 1/4" flat washer, the flow control
lever and a 1/4" nylock hex nut onto the bolt. Do not
tighten yet. See figure 8.
21. Insert the 1/4" x 3/4" hex bolt through the center brace
and the rear of the hopper. Assemble a 1/4" flat washer
and 1/4" nylock hex nut onto the bolt. Tighten both the
front and rear bolts. See figure 8.
CEnTER
BRACE
(O) 1/4" FLAT
WASHER
(K) 1/4" NYLOCK
HEX NUT
(O) 1/4" FLAT
WASHER
FIGuRE 8
22. Insert the 5/16" x 1-3/4" carriage bolt up through the slot
and secure it with a nylon washer and the plastic wing
nut. See figure 9.
23. Move the lift handle into the locked position as shown
in figure 9 and then tip the spreader back to rest on the
wheels and the rear of the hopper.
(GG) PLASTIC WING NUT (P) NYLON
LOCKED POSITION
FIGuRE 9
(G) 1/4" x 1-1/4"
HEX BOLT
(H) 1/4" x 3/4"
HEX BOLT
(K) 1/4" NYLOCK (K) 1/4" NYLOCK
HEX NUT HEX NUT
WASHER
(I) 5/16" x 1-3/4"
CARRIAGE BOLT
EnGLISH
24. Move the flow control lever as far as it will go to the "OFF"
position. Push the feed plate back as far as it will go to
the closed position. See figure 10.
25. Place a nylon washer onto the bent end of the flow control
link and then insert the link into the feed plate bracket.
Secure it with a 3/32" x 3/4" cotter pin. See figure 10.
26. Tighten the lower 1/4" nylock hex nut until it touches the
bottom of the ferrule, then tighten the upper 1/4" nylock
hex nut until it is snug against the top of the ferrule. See
figure 10.
27. Hook the open end of the spring into the feed plate.
Place the closed end of the spring onto the end of the
hex bolt in the flow control lever. Secure it with a 1/4"
nylock hex nut. See figure 10.
28. Open and close the feed plate using the flow control lever.
Check to make sure the feed plate is closed completely
when the lever is in the "OFF" position. If the feed plate
does not close completely, adjust the 1/4" nylock hex
nuts on the flow control link. See figure 10.
(K) 1/4" NYLOCK
HEX NUT
(K) 1/4" NYLOCK
HEX NUT
(CC) FLOW
CONTROL LINK
FEED PLATE
FIGuRE 10
6
FLOw
COnTROL
LEVER
(K) 1/4" NYLOCK
HEX NUT
(II) EXTENSION
SPRING
(U) 3/32" x 3/4"
COTTER PIN
(P) NYLON
WASHER