ION iTT03X Manuel D'utilisation Du Propriétaire page 5

REAR PANEL DIAGRAM
34. Removable Lid - Protects the
turntable from dirt and dust.
35. Hinge Assembly - Holds the lid and
turntable together. Attach now by
sliding the bottom tabs of the Hinge
Assembly into the Hinge Holders.
36. Platter Speed Output - This output is
to be used with external devices that
require platter speed information.
37. Remote Start/Stop - This is used with
external control devices.
Tech note: This circuit is normally
open. Use a momentary switch and
a 1/4" mono plug, to change play
states of the unit.
Your assembly should now be complete. Place your turntable on a vibration free
level surface and attach to your mixer or preamplifier. If you are using the turntable
for slip cueing, scratching, or beat mixing music you will want to use a slipmat and
not a rubber mat. Do not force the platter to stop moving while the motor is
engaged. Quality slipmats should be used to hold records in position. Forcing the
motor to stop can damage the motor assembly.
41 39
34 35
40 37
38. Adjustable Feet - Turn feet to level
the platter surface.
39. Phono Output - Plug these into your
mixer or preamplifiers' turntable
input.
40. Ground Cable - Attach to the ground
screw on your mixer or preamplifier
to prevent turntable hum.
41. Power Cord - Plug this into an
appropriate power outlet after
checking your power setting switch
(18) under the platter.
36 38