Dometic TEC 30D EV Instructions De Montage page 28

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
Connecting the electrical power to the generator
Item
Description
26
6-pin plug
27
2-pin plug
10.4
Connecting 230 V
A
NOTICE!
• Connect the
system so that the generator is not damaged when the external
mains is connected.
• Ensure that the electrical system is set up as follows:
– TN network:
The neutral conductor must be linked to the PE conductor on the
terminal via a jumper with a minimum diameter of 2.5 mm
protect against automatic shutdown, make sure that a safety
switch (FI switch, 30 mA) and an in all-pole overcurrent
protection (e.g. circuit breaker, 13 A) are installed.
– IT network:
Ensure that an insulation monitor and an in all-pole overcurrent
protection (e.g. circuit breaker, 13 A) are installed.
• Connect the generator so that it takes priority over the power supply
(chapter "Creating a priority circuit" on page 30).
➤ Guide the 230 V connection cable through the cable passage in the housing and
connect it to the 230 V terminals (fig. g 5, page 10).
➤ Connect the earth cable to the earth connection on (fig. g 6, page 10).
10.5
Connecting the remote control
➤ Connect the remote control to the control panel of the generator using the
extension cable provided on the plug for the remote control (fig. g 4, page 10).
10.6
Connecting the float
➤ Connect the float from the tank to the Diesel oil gauge connection (fig. g 8,
page 10).
28
relay AG 102 to the vehicle's electrical
changeover
TEC30D EV
2
. To
DE

Publicité

Table des Matières
loading

Table des Matières