Ryobi PBC254YES Manuel D'utilisation page 31

GB
F D E I
PROBLEM
Engine does not reach full
speed and emits excessive
smoke.
Line will not advance
when using automatic line
lengthening.
Blade continues to rotate at
idle speed.
Retaining cap hard to turn.
Grass wraps around the
trimmer head assembly and
the attachment shaft.
Oil drips from muffler.
P NL S DK N FIN GR HU
TROUBLESHOOTING
POSSIBLE CAUSE
1. Check oil fuel mixture.
2. Air filter is dirty.
3. Spark arrestor screen is dirty.
1. Line welded to itself.
2. Not enough line on the spool.
3. Line worn too short.
4. Line tangled on spool.
5. Engine speed too slow.
Carburetor requires adjustment.
Screw threads are dirty or
damaged.
1. Cutting tall grass at ground
level.
2. Operating the product at part
throttle.
1. Operating the product at part
throttle.
2. Check oil/fuel mixture.
3. Air filter is dirty.
CZ RU RO PL SLO HR TR EST LT
English
SOLUTION
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean the air filter according to the instructions
in the Maintenance section.
3. Contact an authorized service dealer.
1. Lubricate with silicone spray.
2. Install more line.
3. Pull line while alternately pressing down on and
releasing the retaining cap.
4. Remove line from spool and rewind.
5. Advance line at full throttle.
Return to an authorized servicing dealer for repair.
Clean the threads and lubricate with grease.
If this does not solve the problem, replace the
retaining cap.
1. Cut tall grass from the top down.
2. Operate the product at full throttle.
1. Operate the product at full throttle.
2. Use fresh fuel and the correct 2-stroke oil mix.
3. Clean the air filter according to the instructions
in the Maintenance section.
24
LV SK BG