Intended Use; General Safety Instructions - Bohle Veribor BO 600.0 Instructions D'installation

Intended Use

06
The suction lifter is a hand tool and is used
exclusively for lifting, carrying and holding objects
with flat, airtight surfaces by hand.
Other applications are not permitted.
Bohle does not assume any liability, if:
The suction lifter is not used according to its
¡ ¡
intended use.
The suction lifter is modified or remodelled
¡ ¡
without authorisation.
Components or spare parts from other
¡ ¡
manufacturers are used.
The suction lifter is used incorrectly or by
¡ ¡
unauthorised persons.
The suction lifter is not serviced regularly.
¡ ¡
The warnings, notes and regulations of these
¡ ¡
operating instructions are not observed.
WARNING
Improper use of the device may lead to
dangers!
Use the device exclusively for its intended
¡ ¡
purpose.
Observe the procedures described in these
¡ ¡
operating instructions.
20
General Safety
07
Instructions
Observe the following rules to achieve a high level
of safety when using the suction lifter:
Follow the guidelines in these operating
¡ ¡
instructions.
All work on the suction lifter (start-up,
¡ ¡
operation, maintenance, troubleshooting and
fault rectification) must only be carried out by
qualified personnel or people instructed and
trained for the intended work.
Never use the suction lifter as a support for
¡ ¡
people.
Never use the suction lifter in conjunction
¡ ¡
with a crane or other lifting equipment. The
corresponding prohibitory sign is attached to
the suction lifter:
The suction lifter has a specified maximum
¡ ¡
load capacity. These values only apply to new
suction lifters and clean, dry and flat glass
panes at an ambient temperature of 20°C
and an ambient pressure of 1013 mbar after
generating the maximum vacuum.
Note that the air pressure decreases the
¡ ¡
higher you are above sea level and therefore
also reduces the load capacity. Starting from
1,600 m above sea level, the use of suction
lifters is only possible to a limited extent.
The holding capacity is significantly reduced
¡ ¡
up to its total loss in cold, humid or dirty
conditions, in particular if the suction pad
is not maintained or is damaged, and when
lifting or carrying other materials than flat
glass (e.g. decorative glass, plastic, stone,
metal etc.).
Always check the suitability of the lever-
¡ ¡
activated suction lifter for its intended use.
Secure the objects to be lifted or carried
against falling or slipping.
Suction lifters must not be subjected to
¡ ¡
extreme heat (e.g. open flames, constant
direct sunlight). Temperatures consistently
above approx. 40°C must be avoided at all
costs.