Adjusting The Air Flow Direction - Argo AWIAS7DC Notice D'utilisation

3742540532-U-AWIAS7-BS9DC

ADJUSTING THE AIR FLOW DIRECTION

HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving the
vertical vanes to the left or right, as indicated in the following
figures.
Vertical vane
VERTICAL (with remote control unit)
Make sure that the remote control unit has been turned on.
the FLAP button to select the flap function
Fixed:
six
position
The flap automatically closes when the unit
l
NOTES
is off.
When the unit starts in heating operation,
l
the fan stops and the flap is in the 4 position
(if automatical oscillation is selected) until
the air being blown out of the unit begins to
warm. Once the air warms up, the flap
position and fan speed change to the settings
specified with the remote control.
20-07-2015 8:49
Right
Left
Press
Continous Automatical
oscillations oscillations
Pagina 9
CAUTION
Do not move the flap with your hands when the air
conditioner is running.
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
Flap
Air outlet
grille
HOW TO ADJUST THE FLAP DIRECTION
Zone «A»
for cooling and dehumidifyng
CAUTION
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
9
Up
Down
Zone «B»
for heating
EG