Sauna Heater; Control Panel - Helo SKSM D Instructions D'installation Et D'utilisation

REWARD YOURSELF
INSTRUCTIONS FOR INSTALLATION AND USE

SAUNA HEATER

CONTROL PANEL

We wish you many hours of relaxation and pleasure in your sauna. Please read the instructions beneath very
carefully in order to find out how the sauna works.
ATTENTION: The sauna heater must be connected to the power supply by a qualified electrician and in
compliance with current regulations.
INSTALLATION OF THE HEATER
For information about how to install the heater, please see page 3. When mounting the heater, please take note of the
following:
- Follow the given instructions
- Wood panelling is the approved material for walls and ceiling in the sauna room.
- Check that the wall panelling is secured where the screws will be fastened.
- Only one sauna unit may be installed in a sauna room.
- The heater must not be surrounded by a compact heater guard.
Before installing the heater, please check the following:
- That the following parts have been delivered: heater, control box with temperature sensor device.
- That the voltage of the heater and control box is correct and that the control box is suitable for the heater
- That the kW of the heater corresponds with the size (m ) of the sauna room. See table 1
- That the minimum construction distances in fig. 2 are strictly followed
MOUNTING THE SAUNA HEATER (See fig 2)
Drill the four screw holes using a 3,5 mm2 drill bit. The screw head should be approx. 3 mm from the wall
surface.Make sure that the screws are fastened through the sauna room soft wood lining into a backing board to
hold the heater.
Hang the heater on the screws. Tighten the lower screws in order to lock the heater in position. Re-chech your
distances from the heater to combustible materials to make sure the stipulated minimum distances are followed.
MAIN CONNECTION
The cable used must be at least rubber coated HO7RN-F type. Also other cables coming from the heater (such as those
for the signal lamp, locking circuit for other heating appliances) should be of corresponding type and have a similar
cross-section as the above mentioned.
To connect a heater with an one-piece bottom part:
- Remove the screws (1) on both sides of the heater.
- Remove the bottom part.
- Connect the heater
- Mount the bottom part.
- Mount the screws (1) back.
To connect a heater with the connection box behind the type plate:
- Remove the screws (1) on the type plate.
- Remove the type plate.
- Connect the heater.
- Put the type plate back.
- Mount the screws (1) back.
1712-30-04
1712-45-04
1712-60-04
1712-80-04
1712-90-04
1418- 2 - 1517
1.
1.