Whirlpool GLADIATOR GAWG241DRG Instructions D'assemblage page 4

24" (60.96 cm) Cabinet
2.
Attach bracket
F1
F1
With the rims of a mounting bracket pointing down, align the
holes in the bracket with the pair of holes in the back panel.
Working from the back, insert a 1/4"- 20 x 1/2"carriage bolt (F1)
through the bracket and back panel as shown. Working from the
cabinet interior, fasten each bolt with a washer (F2) and
a hex nut (F3). Completely tighten the nuts.
30" (76 cm) Cabinet
2.
Attach bracket
F2
F1
F1
F1
With the rims of a mounting bracket pointing down, align the
holes in the bracket with the pair of holes in the back panel.
Working from the back, insert a carriage bolt (F1) through the
bracket and back panel. Working from the cabinet interior, fasten
each bolt with a washer (F2) and a hex nut (F3). Completely
tighten the nuts. With the rims of the mounting bracket pointing
down, align the holes in the bracket with the pair of slots in the
back panel. Working from the back, insert a carriage bolt (F1)
through the lower bracket and back panel. Working from the
cabinet interior, fasten each bolt with a washer (F2) and
a hex nut (F3). Only hand tighten the nuts. The lower bracket will
need to be adjusted to mount the cabinet on the wall.
IMPORTANT: Completely tighten the hex nuts (F3) on the lower
bracket after mounting the cabinet on the wall.
4
25-Feb-2021 08:06:20 EST | RELEASED
F2
A. Bracket rim
F2 F3
F3
F3
F2
F3
F2
F2 F3
In some European factories the letter "W" of the part code mentioned herein will be automatically
3.
Install cabinet
F3
A
B
A
A. Bracket rim
B. Slot
IMPORTANT: If installing cabinet on GearTrack
second channel should be installed 18" (45.72 cm) below the
bottom of the supporting channel so the cabinet will hang level.
Close the cabinet door. Determine cabinet mounting location on
a GearWall panel or GearTrack
®
people, engage the mounting bracket into the wall slots by lifting
up, pushing toward the wall and lowering the bracket rims into
the slots as shown. Make sure the mounting bracket is fully
engaged in the slots as shown. If you want to reverse the door,
see "Reverse Door." Permanently affix the magnetic latch to the
cabinet by removing the paper backing from the adhesive and
firmly pressing it to the cabinet.
3.
Install cabinet
A
B
A. Bracket rim
B. Slot
Close the cabinet doors. Determine cabinet mounting location
on GearWall
®
people, engage the top mounting bracket into the wall slots by
lifting up, pushing toward the wall and lowering the bracket rims
into the slots as shown. Make sure the top mounting bracket
is fully engaged in the slots as shown. Open the cabinet doors.
From the cabinet interior, lift up on the two lower bolts to adjust
the lower mounting bracket so that it aligns with the slots on
the GearWall
®
toward the GearWall
lower bracket rims into the slots. Make sure the bottom mounting
bracket is fully engaged in the slots. Using a 1/2" wrench, tighten
the two nuts on the bottom wall mounting bracket.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
C
C. Mounting bracket fully engaged
channels. Using two or more
®
C
C. Mounting bracket fully engaged
panel or GearTrack channels. Using two or more
®
panel or GearTrack channels. Push the cabinet
®
panel or GearTrack
® ®
channel, a
®
channels and lower the