USRobotics Serial ATA 4-Drive NAS Guide D'installation Rapide page 12

English
If the System Initialization page appears, you need to initialize your disks:
If not all the hard disks have been detected, or if you want to add, remove, or reorder the disks at this
time, insert or remove the disks one at a time and click Scan after each action. If you're adding disks,
be sure to wait until the Disk LED is blue before you click Scan.
Note: USRobotics strongly recommends that you install all the hard disks that you want to use in
the storage system at this time, since changing the number of hard disks later can require
disk reconfiguration and possible data loss.
3. Click Browse and locate the USRobotics Installation CD-ROM.
4. Double-click the file inside the Firmware folder.
5. On the System Initialization page, click Upload.
The firmware on the storage system's internal flash memory is uploaded to the hard disks.
12