Universal Remote Control - Hama 00012306 Mode D'emploi

G Operating instruction

Universal Remote Control

Thank you for your decision for a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference.
Function buttons (Models 4 in 1, 8 in 1)
1. Mute Switch
2. Device selection keys
3. Text ON: Switch on Teletext
4. Hold: Hold the current Teletext page
5. ◄◄ Rewind/red
► Play/yellow
►► Fast forward/blue
● Start recording
■ Stop/green
ll Pause/magenta
6. Shift key
7. Menu: Open device menu
8. Mode key for selection of secondary device
group (only 8 in 1 model: AUX,DVBT,CBL,AMP)
9. Vol+/Vol-: Volume control
10. Setup: Remote control settings
11. Number Keys 0-9
12. Smart TV: open smart TV menu (if supported by
the terminal device)
Shift+Smart TV: select external AV source
13. APPS: open app menu (if supported by the
terminal device)
Shift+APPS: switch to two-digit TV station numbers
14. PROG+/PROG-:Programme selection up/down
15. EXIT: exits device menu
16. OK: Confirms a selection
17. EPG: Electronic Programme Guide (if supported
by selected A/V device)
18. Info: On-Screen information (if supported by
A/V device)
19. Text OFF: exits Teletext
20. Power: ON/OFF / LED indicator
1. Explanation of the Note symbol
Note
► This symbol is used to indicate additional
information or important notes.
2
2. Package Contents
- Universal Remote Control (URC)
- Code List
- This operating instructions
3. Safety notes
• Do not use the Universal Remote Control in mo-
ist or wet environments and avoid spray-water
contact.
• Do not expose the Universal Remote Control to
heat sources or direct sunlight.
• Do not drop the Universal Remote Control.
• Never open the Universal Remote Control.
It contains no user-serviceable parts.
• As with all electrical devices, keep the Universal
Remote Control away from children.
4. Getting started – installing the Batteries
Note
► Alkaline batteries are recommended. Use
2 „AAA" (LR 03/Micro) type batteries.
► Remove the battery compartment lid on the
back of your URC (A).
► Check the required battery polarity and in-
sert batteries according to the "+/–" marks
inside the compartment (B).
► Close battery compartment lid (C).
Note: Code saver
► Any codes you have programmed remain
stored for up to 10 minutes while you re-
place the battery. Make sure you do not
press any buttons before you have placed
new batteries inside the remote control.
All the codes will be erased if a button is
pressed while there are no batteries in the
remote control.