Introduction; Startup Procedure - Mettler Toledo LC-P43 Mode D'emploi

Introduction

The LC-P43 is a rugged and simple to operate dot matrix printer for balances from METTLER TOLEDO with a LocalCAN universal interface (balance lines AB, PB,
CB, GB, College-B, SB with LC-B option, AG, PG, SG, PR, SR and PG-S with LC-G option). The printout on normal paper fulfills the requirements of modern
quality assurance systems (GLP, GMP, ISO 9000, etc.). These define, among other things, the principles and duties for the user of measuring instruments or
inspection, measuring and test equipment. The LC-P43 complies with the principle of traceability of measurements by precisely documenting the origin of data,
as well as calibration procedures. It fulfills the obligation to archive measurement results by its chemically resistant, thermally stable and lightfast print. The
LC-P43 prints all data sent by the balance without restriction, that is not only weight values and calibration procedures, but also naturally the results of all
applications such as piece counting built into the balance.

Startup procedure

Cautionary notes
For reasons of safety, the housing of the printer must not be opened by the user. If technical faults appear or if the printing unit or power line fuse has to be
changed, please notify METTLER TOLEDO service.
• The LC-P43 Printer may be used only indoors and on no account in hazardous areas.
• The electronics of the LC-P43 Printer are protected against the ingress of splashing water and dust. However, as the
printer housing is not tight the printer should not be used in the presence of liquids.
• Comply with cleaning instructions (see page 8), protect power plug against wet conditions.
• Never open the printer housing. Should you ever have problems with your printer, please contact the responsible
METTLER TOLEDO dealer.
4