Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.4.6. Configuring the countdown timer
The duration of the countdown can be configured to the nearest minute, between 1
and 10 minutes.
menu
Press
for 2 seconds, then on
is displayed, then adjust the required value using the
keys.
Press
to exit setup mode, or time out after 10 seconds.
2.4.7. Simulation mode
Simulation mode can be accessed via the Configuration menu. This mode is shown
by the icon
cut off. It may be used for sales demonstrations of the product and features the
following functions:
•
Displays a coherent bottom profile (in distance and variation),
•
Displays a coherent boat speed (in absolute value and in acceleration),
•
Displays a speed over ground related to the simulated boat speed,
•
Displays a coherent water temperature,
•
Displays the real supply voltage,
•
Transmits simulated data via the NMEA output.
•
Transmits simulated data via the communication bus.
menu
Press
for 2 seconds, then
displayed, then activate (on) or deactivate (OFF) simulation using the
and
keys.
Press
to exit setup mode, or time out after 10 seconds.
2.4.8. Key beeps
The key beeps can be activated or deactivated.
menu
Press
for 2 seconds, then
displayed, then activate (on) or deactivate (OFF) the beep using the
and
keys.
to exit setup mode, or time out after 10 seconds.
Press
menu
until the "tIME" setup page
flashing on the LCD and remains active after power has been
menu
until the "SIMUL" page is
menu
Installation and Operation Manual S400 series
and
until the "bIP" page is
14
Publicité
Chapitres
Table des Matières
