Setting The Battery Alarm Threshold; Configuration; Keel Offset; Speed Damping - ADVANSEA MULTI S400 Manuel Utilisateur

Masquer les pouces Voir aussi pour MULTI S400:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.3.3. Setting the battery alarm threshold

The battery alarm allows you to monitor the supply voltage to your installation. This
is important, particularly for good sounder performance.
menu
Press
, then once again on
threshold page, then adjust the required value of the threshold using
the
and
Press
to exit setup mode, or time out after 10 seconds.

2.4. Configuration

2.4.1. Keel offset

The depth displayed on the Multi display represents the distance between the probe
mounted on the hull and the bottom, plus or minus the keel offset:
For a positive offset, the depth is measured from a point located above
the probe (Depth = distance between probe and bottom + Offset).
For a negative offset, the depth is measured from a point located below
the probe (Depth = distance between probe and bottom - Offset).
To adjust this offset:
menu
Press
for 2 seconds, then on
displayed, then adjust the required value using the
keys.
Press
to exit setup mode, or time out after 10 seconds.

2.4.2. Speed damping

A damping coefficient is available to the user for boat speed. Depending on
navigation conditions, this parameter can be adjusted to between 1 and 30.
menu
Press
for 2 seconds, then on
is displayed, then adjust the required value using the
keys.
Press
to exit setup mode, or time out after 10 seconds.
menu
keys.
menu
menu
Installation and Operation Manual S400 series
to display the "bAt" low
until the "kEEL offset page is
and
until the "dAMP" setup page
and
12

Publicité

Chapitres

Table des Matières
loading

Table des Matières