Settings - Prodipe Pro5 V3 Manuel Utilisateur

3 - Settings

There are different settings on the rear panels of your monitors:
VOLUME
You can adjust the gain setting at the back of the monitor using the changeover switch in Figure 3.
It can be set from -30dB to +6dB.
ADJUSTING THE HIGH FREQUENCIES (HF LEVEL) – Pro5 v3 and Pro8 v3 only
You can adjust the high frequencies at the back of the monitor (Figure 4). The possible values are -
2dB, -1dB, 0dB (flat), 1dB, or at around 2 kHz. The crossover frequency between the tweeter and
the woofer is 3KHz (Pro5 V3) and 2.4KHz (Pro8 V3).
ADJUSTING OF THE LOW-PASS FILTER - Pro10s V3 only
By adjusting the low-pass filter you can set the high cutoff frequency so that the performance of
the subwoofer is optimised relative to your front speakers. The subwoofer audio outputs that
connect to your speakers rely on a high-pass filter to ensure that any subwoofer infrasound is
eliminated.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2016 IPE Music/Prodipe
Figure 16
Figure 17
Figure 18
Page 17