Connections - Prodipe Pro5 V3 Manuel Utilisateur

2 – Connections
To ensure the proper implementation of your monitor system, please adhere to the following
procedures at all times:
1. Check your audio lead.
2. Switch on the other equipment you intend to use (audio mixer, PC, audio source, etc.)
3. Check your monitor settings and the settings of your audio sources (lowest volume).
4. Check the voltage (2), switch on the Prodipe monitors by putting switch (1) in the ON
position and the blue LED  will light up.
Note that: when you want to shut everything down, the Prodipe monitors must be switched off
first, switch (1) in the OFF position and the blue LED (3) off.
Careful: choosing the "AC Select" (2) voltage depends on your power supply. You should make
any changes when the system has been switched off, switch (1) in the OFF position and the power
supply lead unplugged.
SOURCE
AC SELECT (2)
FUSIBLE (4)
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2016 IPE Music/Prodipe
Pro 5 V3
100V – 220V –
120V 240V
115V 230V
1A 500mA
Figure 15
Pro 8 V3
100V – 220V –
120V 240V
115V 230V
2A 1A
Pro 10s V3
100V – 220V –
120V 240V
115V 230V
3.15A 1.6A
Page 16