ohmex AIR 9000 CON Manuel D'utilisation page 104

EN
Water drainage
• Turn the appliance off and disconnect the plug from the socket.
• Place the appliance near a water unloading point or position a container in the rear
part of the appliance.
• Remove the cover (11)
• Remove the cap (10); water immediately leaks from the joint.
If desired, connect a small hose (not supplied) to the unloading joint to better
direct water.
☞
Do not perform this operation on wooden floors, on carpets or
wall-to-wall carpeting. Make sure that leaking water doesn't
enter in contact with delicate objects, with cables or power
sockets.
• Let all water leak. It is not necessary to tilt the appliance.
• Correctly reposition the cap (10) and the cover (11).
• Insert the plug in the socket.
• The appliance will emit an acoustic signal indicating that it is in stand-by mode. The
display shows the detected ambient temperature.
Press the ON/OFF button (20 or 40) to start the appliance.
•
100
CLEANING
11
10
AIR 9000 CON
10