Field Of Application - Würth 1952 006 650 Traduction Des Instructions De Service D'origine

DE
GB
INTRODUCTION FR
Please read this manual before carrying out any operation.
It is compulsory to read this instruction manual before starting any
NL
kind of action.
The proper operation and full compliance of this product's
ES
performance is guaranteed only if all the instructions provided in this
manual are closely adhered to.
IT
We guarantee that this product complies with the technical
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
PT
uses other than those described herein.
Use protective work gloves, protective footwear, hard hat and safety
PL
goggles.
DA
Misuse:
- This product should only be used as described in this
EL
documentation; any other use is considered improper.
- The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
16
METHOD OF PREPARATION

FIELD OF APPLICATION

The set of compression frames described in this document is used to
mount/remove silent bearings, sockets and bushings on/from cars,
SUVs and vans. You can work directly on the vehicle!
The set of compression frames is supplied with a mechanical spindle
but, at customer's discretion, can be operated by a hydraulic unit
which can be supplied on request.
The adapters-spindle makes it possible to also use the support of the
set of commercial pressers.
This set consists
1 x item for upper support with 2 reduction-thread adapters
1 x item for TR27 thrust screw
1 x item for adapter for TR27 screw for coupling of commercial
2 x items for adapters for Wurth pushers system
1 x item for open lower support
1 x item for insertion ring for open lower support
1 x item for lower support with TR20 threaded bushing
1 x item for TR20 short thrust screw with coupling for adapter for
1 x item for TR20 long thrust screw with coupling for adapter for
1 x item for adapter for TR20 thrust screw for coupling to
2 x items for 210 mm-long press frame columns
2 x items for columns/extensions for 125 mm-long press frame
FRAME TECHNICAL DATA
of:
pushers system
commercial pushers
commercial pushers
commercial pushers system
Total height 290/415 mm
Total width 170mm
Aperture/width 113mm
Working height 210/335mm
Coupling thread TR27/1-1/2"x16G/2-3/4"x16G (upper
support)
TR20 (closed lower support)