Baby Unit; Troubleshooting - Philips SCD589 Mode D'emploi

Problem
LINK light (A-3, B-3)
does not light at all.
LINK light (A3, B-3)
flashing red/alarm
beeping on parent unit.
Charging time of parent
unit batteries exceeds
16 hours.
Possible cause
Parent unit:
Power adapter (B-14) not
plugged in.
Unit not turned on.
Batteries are low.
Batteries are empty.

Baby unit:

Power adapter (A-14) not
plugged in.
Unit not turned on.
Batteries are low.
Units out of range.
Baby unit batteries are low.
Parent unit batteries are low.
Parent unit batteries are empty.
Units cannot establish connection, Try solving the problem by using
even when close to each other.
No power on one of the units.
Parent unit switched on during
charging.

Troubleshooting

Solution
Connect power adapter (B-14) to
wall outlet.
Press and hold On/Off button (y)
(B-6) for two seconds.
Recharge batteries (B-12).
Replace batteries (B-12).
Connect power adapter (A-14) to
baby unit.
Connect power adapter (A-14) to
wall outlet.
Press and hold On/Off button (y)
(A-1) for two seconds.
Replace batteries (A-12).
Decrease distance between units
(see 'Technical specifications).
Replace batteries (A-12).
Recharge batteries (B-12).
Replace batteries (B-12).
the factory initialization mode.
See chapter 'Factory initialization
mode'
Press On/Off button (A-1, B-6)
for two seconds.
Switched off parent unit (B-6).
EN
19