Regeneration Cycle - Whirlpool AGB 641/WP Manuel D'emploi

11.1

REGENERATION CYCLE

Warning: the regeneration cycle must be carried out at the end of the day or during rest
periods.
To carry out the regeneration cycle proceed as described below: move the general switch 1
located on the control panel to position "0".
Remove the power plug from the mains socket.
Remove the overflow pipe (Pag. 3 - Pos. 3).
Fill the salt container located in the tank with 1 Kg. of coarse cooking salt, making sure that
the cap is replaced securely (Fig. 7).
Fit the power plug into the mains socket.
Press the regeneration button 5, at the same time the pilot light 6 will come on.
When the regeneration cycle has been completed (20 minutes), pilot light 6 will go out.
Open the door again and refit the overflow pipe then follow the start-up - initial load instructions.
Check and top up the salt after every 5 regeneration cycles.
Before carrying out any maintenance operation, consult the chapter "Safety regulations".
Cut off the electric power to the dishwasher using the general switch 1 located on the
control panel and then remove the plug from the mains socket.
MODELS WITH DISCHARGE PUMP
11.2
The machine automatically discharges the water and keeps the level of the same constant
inside.
To empty the tank completely, move the general switch 1 located on the control panel to "0".
Press button 9 as shown in the figure; wait until the tank has been completely emptied.
12
MANUAL TANK DRAIN
After completing the wash cycle proceed as follows:
- set the master switch to "OFF";
- disconnect the wall master switch;
- turn water supply pipe off;
- remove overflow H (to allow the appliance tostart draining) (Fig. 10);
- remove filter G on draining completion (Fig. 10);
- wash the tank interior and filters with suitable products;
- place filter and the overflow back to the relevant positions.
ENGLISH 25