Product Overview - ACU-RITE IOB 610 Guide D'utilisation

5.3

Product overview

The 15-pin D-Sub connection on the front panel of the
device is protected by a dust protection cap from
contamination and damage.
NOTICE
Contamination or damage may result if the dust
protection caps are missing!
This may impair the proper functioning of the contacts
or destroy them.
Remove dust protection caps only when connecting
measuring devices or peripherals
If you remove a measuring device or peripheral,
reattach the dust protection cap to the connection
Front panel without dust protection cap
Further information: "A", Page 2
Front panel
1 X102: terminal block connection for switching inputs
X10: 15-pin D-sub connection for compatible digital
2
readouts
X101: terminal block connection for switching outputs
3
and analog output
14
5.4 Connecting a DRO
Remove and save the dust protection cap
Route the cable depending on the mounting variant
"Assembly", Page 12
Further information:
Connect the connecting cable tightly to connection X10
Further information: "Product overview", Page 14
If the cable connector includes mounting screws, do
not overtighten them
Pin layout of X10
Further information: "G", Page 215
5.5 Connecting a terminal block
Remove the male terminal connector from the module
connection
Insert the required + and - wires for switching inputs or
the required output wire for relay outputs into their
respective terminals on the male terminal connector
Tighten the screws located on the top of the cable
connector using a small flat-edge screwdriver
Insert the male terminal connector into the connection
on the IOB
Further information: "Product overview", Page 14
Pin layout of X101 and X102
Further information: Page 211 and Page 213
ACU-RITE | IOB 610 | Operating Instructions | 04/2018