Battery Pack; Capacity Display; Settings - Festool ISC 240 Li Mode D'emploi Original

English
Insulating material
PUR/PIR
< 36 kg/m³
Polystyrene
< 45 kg/m³
7

Battery pack

► Inserting the battery pack [2a]
► Removing the battery pack [2b]
7.1

Capacity display

The capacity display [2-1] indicates the charge
of the battery pack for approx. 2 seconds after
the button [2-2] is pressed:
Recommendation: Charge the battery pack
*
before any further use.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8

Settings

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
18
Saw blade
70‑100%
40‑70%
15‑40%
< 15% *
WARNING
Sharp saw blades
Risk of injury
► Attach the protective cover to the cutting
set when performing any work on the pow­
er tool.
8.1 Fitting a cutting set [3]
WARNING
Sharp, incorrectly inserted saw blades
Risk of injury
► Never insert individual saw blades into the
power tool.
► Only use saw blades in conjunction with a
cutting set.
► Always combine saw blades with the asso­
ciated guide rail.
► If necessary, push the extractor connec­
tor [3-1] upwards.
► Release the rotary knob.
► Open the cover flap.
► Turn the lever on the clamping
sleeve [3-2] anti-clockwise to unlock the
clamping sleeve.
► Pull the movable saw blade on the sin­
gle-cam shaft (T shaft) [3-4] along the
guide rail [3-3] as far as it will go to remove
it.
► Push the movable saw blade into the
clamping sleeve as far as it will go.
► Turn the cutting set clockwise by ap­
proximately 30° until the guide rail is level.
The retaining pins [3-5] in the guide rail holder
are seated fully in the recesses in the guide rail.
When tightening the rotary knob, always
keep the cover flap pressed down. Other­
wise, the thread could become damaged.
► Close the cover flap.
► Keep the cover flap pressed down and
tighten the rotary knob.
8.2 Removing the cutting set [4]
► If necessary, push the extractor connec­
tor [3-1] upwards.
► Release the rotary knob.
► Open the cover flap.
► Turn the lever on the clamping
sleeve [4-1] anti-clockwise.
The clamping sleeve is unlocked.