POLO HI-Q TOOLS Mode D'emploi page 3

HI-Q TOOLS ALUMINIUM RACING WORK STAND
(REAR)
Ord. Nr. 60150700010
CONTENT
1 motorcycle lift
2 V-shaped supports
he HI-Q TOOLS aluminium racing work stand (rear) simplifi es a lot of reparation and mounting
work on your two-wheeler. Modern motorcycles often have a high empty weight of several
hundred kilogramms. Therefore please use the HI-Q TOOLS aluminium racing work stand (rear)
always with the greatest care in accordance to these operating instructions and the manu-
facturer's specifi cations to avoid damage on your two-wheeler and injuries on involved persons.
The HI-Q TOOLS aluminium racing work stand (rear) with the delivered V-shaped supports is only
appropriate for jacking up motorcycles with bobbins. Please note that the width of the swing
arm (support of the bobbins) shall not exceed the dimensions of approx. 25-36,5 cm.
Never use the HI-Q TOOLS aluminium racing work stand (rear) for other purposes.
ASSEMBLY
The HI-Q TOOLS aluminium racing work stand (rear) is ready as soon as the V-shaped supports
(pointing inwards) are put into the open bars of the lift and fi xed with the 4 screws (on each
side). The HI-Q TOOLS aluminium racing work stand (rear) is not appropriate for triangle swing
arms or hooked „banana swing arms" without thread supports or one arm swing arms.
USE
Before using the HI-Q TOOLS aluminium racing work stand (rear) check if your motorcycle ge-
nerally fulfi ls the conditions to be lifted by the HI-Q TOOLS aluminium racing work stand (rear).
The max. load capacity is 150 kg – therefore the total weight of the two-wheeler incl accessories
may not exceed 300 kg. The rear swing arm has to be appropriate for the lift (no construction
forms as described above without threaded bodies for bobbins). If the rear swing arm shall be
demounted, the axle has to be loosened before jacking up the motorcycle. The same is valid for
other tightened boltings on the two-wheeler. Never jack up the motorcycle alone – let yourself
help by a second strong person, keeping the motorcycle on the handlebar in vertical position.
Lifting the two-wheelers if it is standing inclined on the side stand, can damage the HI-Q TOOLS
aluminium racing work stand (rear) an may cause that the vehicle slips off.
60150700010-Bedienungsanleitung.indd 5-6
USE WITH V-SHAPED SUPPORTS
Assemble the V-shaped supports and adjust the width of the HI-Q TOOLS aluminium racing work
stand (rear) on your two-wheeler. Put the V-shaped supports from the back on the bobbins of
the motorcycle and move the supports so they are coating completely the pre-mounted bobbins
of the swing arm. Before lifting the motorcycle make sure again, that the HI-Q TOOLS aluminium
racing work stand (rear) is safely assembled and the helping person keeps the vehicle safely in
position. Then press the motorcycle lift on the connection tube strongly but slowly under the
vehicle until it lies on the lift. Make sure the V-shaped supports have no contact with the swing
arm in any position to avoid damage on the swing arm.
Thus we can guarantee the correct mounting and use of the product.
State: 01/2015
GB
21.04.15 15:40