General Maintenance; Lubrication; Replacing The Blade - PRO-PULSE 02255002 Manuel De L'utilisateur

MAINTENANCE
WARNING:
!
may create a hazard or cause product damage.
WARNING:
!
tool operation or when blowing dust. If operation is dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage
from various types of commercial solvents and may be damaged by their use. Use clean
cloths to remove dirt, dust, oil, grease, etc.
WARNING:
!
manufacturer of this product. The use of attachments or accessories not recommended can
result in serious personal injury.
Periodically check all nuts and bolts for proper tightness to ensure safe operation of the mower.
Remove any buildup of grass and leaves on or around the motor cover. Wipe the mower clean
with a dry cloth occasionally. Do not use water.

LUBRICATION

All bearings in this product are lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions. Therefore, no further
bearing lubrication is required.
At the beginning and end of each mowing season:
■ Lubricate the springs on the rear discharge door with light oil.
■ Lubricate the height adjustment lever and related hardware with light oil.
■ Remove the wheels and lubricate the surface of the axle bolt and the inner surface of the
wheel with light oil.
■ Romove the blade and blade hub assembly and lubricate the motor shaft with light oil or
engine oil. See Replacing the Cutting Blade for instructions on removing the blade.
WARNING:
!
edges of the blade with rags and other material when performing blade maintenance. Failure
to heed this warning could result in serious personal injury.
WARNING:
!
the power supply. Failure to heed this warning could result in serious personal injury.
BLADE
When servicing, use only identical replacement parts. Use of any other parts
Always wear safety goggles or safety glasses with side shields during power
Do not use any attachments or accessories not recommended by the
Always protect hands by wearing heavy gloves and/or wrapping the cutting
Before performing any maintenance, make sure the mower is unplugged from

REPLACING THE BLADE

NOTE: Only use identical replacement blades.
■ Stop the motor and disconnect the power
supply. Allow the blade to come to a complete
stop.
■ Turn the mower on its side.
■ Wedge a block of wood between the blade and
mower deck to prevent the blade from turning.
■ Loosen the blade nut using a 14 mm wrench or
socket (not provided).
■ Remove the blade nut, and blade.
■ Make certain the fan assembly is pushed
completely against the motor shaft.
35